Enhance Your Home Comfort With These DIY Furnace Troubleshooting Tips

Here are some troubleshooting tips and tricks by furnace service experts in Huntington, NY, that can help you fix and restore the furnace’s functioning:

Check and replace the air filter

The air filter is an essential component in the furnace assembly, and most problems start when you forget to replace the air filter. Using the same old dirty filter can cause numerous problems, like airflow issues and overheating, affecting the home’s comfort and increasing the furnace system’s workload.

It is better to replace it every three months and clean it weekly to ensure your furnace functions efficiently and doesn’t affect indoor air quality.

Check the thermostat settings

Occasionally, the furnace can work improperly due to incorrect thermostat settings. That’s why it is better to check the thermostat settings before calling the furnace service experts in Huntington, NY.

Here are the following things that you should check:

• Ensure the thermostat is set to heat and the temperature is slightly above room temperature.
• The fan is set on AUTO mode rather than ON mode.
• Replace the thermostat batteries if you haven’t replaced them in a while.
• If you have an electric thermostat, remove from its place, open it up, and clean it gently with a soft brush.
  Moreover, check the thermostat wiring. Call the experts if the wires seem broken, out of place, or loosened from their place to you.

Check the electrical panel and fuse box

The circuit breaker can trip due to an increase in voltage. Check the circuit breaker. If the furnace switch is flipped down, try to flip it back. If it keeps blowing up, call our furnace repair expert in Huntington for an inspection.

Check the pilot light

The pilot light provides a necessary spark to necessitate combustion. However, if the pilot light is not glowing, our furnace installation expert in Huntington NY recommends referring to the furnace installation booklet to re-ignite the pilot light.

Check for the gas valve

The gas valve supplies the natural gas to the furnace system for combustion. However, if there is a leakage or the gas valve is turned around, the furnace might not receive sufficient fuel for combustion.

Situations when it is best to leave the things to a furnace technician

Sometimes, it is best to leave the things to our furnace installation in Huntington, NY to repair. In the following cases, it is better to switch off the system and wait until the next day for our technician to fix the system:

• Strange and loud sounds like screeching, clicking, rattling, humming, and squealing
• Burning and gas odors can indicate serious electrical or gas leakage issues
• The pilot light flickers or glows yellow and orange
• Water pool formation near the furnace system
• The circuit breaker trips down again as you flip it up again
• If the furnace system does not responds to the thermostat changes or delivers inadequate heat, call the expert for an inspection